Marine Engineering on the Gold Coast
With large taper turning capacities on both our large Lathes, we can accurately turn your new propeller shaft to suit your boat up to 100m in diameter
In the variety of works performed in our modern Engineering Shop reclamation work of worn surfaces is often a lot cheaper to repair than replacing with new
For a Free Quote do not hesitate to contact our experienced staff with regards to your job.
Worn seal areas on leaking rudder areas can be spray welded up at a fraction of the coast of replacing new
Heat Exchangers, Engine Oil Coolers and Gear Box Coolers which are clogged up and badly corroded can be chemically cleaned, welded up, machined back to tolerances. Seals fitted and Pressure Tested at a fraction of a cost to replace new.
Raw Water Pumps stripped, bead blasted to bring them up like new, new wear plates modified in Housing to suit and assembled with new impeller bearings and seals
Straightening of bent rudder and propeller shafts